Тестовая система электростатических разрядов
для проверки бортового космического оборудования
в соотв. ECSS-E-ST-20-07C
ECSS‐E‐ST‐20‐07 ESD
Тестовая система электростатических разрядов
для проверки бортового космического оборудования
в соотв. ECSS-E-ST-20-07C
ESD test setup for spacecraft equipment ECSS‐E‐ST‐20‐07 ESD
Montena develops and manufactures pulse generators for testing the susceptibility of space equipment to electrical transients coupled into wires by electrostatic discharges (ESD).
The ESD test method according to ECSS-E-ST-20-07C §5.4.12, which is commonly used in space industry, has shown weaknesses in reproducibility. The experience has shown that test results can vary from one test laboratory and setup to another, this entails developing an improved methodology and hardware to address the ECSS test shortcomings.
Our newly developed PESD-ECSS-12K test system consists of:
- a pulse generator replacing the spark gap defined in ECSS which is difficult to procure
- a Bulk Current Injection (BCI) probe to be installed on the cable harness. With this tool, the application of the test becomes much simpler than winding by hand a coupling wire around the harness and fixing it with taper.
This system is the first commercially available solution replacing the ECSS setup that was requiring discrete components to be wired on the table.
The generator and the suggested test set-up have been evaluated in different configurations showing an improved reproducibility and a simpler testing procedure. Tests performed with this new system present the same severity as the ECSS wire injection method and are therefore accepted as equivalent.
ADVANTAGES
- Reduced set up time
- Improved test reproducibility
- Complete set of accessories for test and measurement available
Номер в Госреестре | Наименование СИ | Обозначение типа СИ | Изготовитель | Срок свидетельства или заводской номер |
---|---|---|---|---|
Подлежит аттестации в соответствии испытанию на ГОСТ |
SPECIFICATIONS
Proposed test setup for BCI injection of ESD pulses
EQUIPMENT | REFERENCE | SPECIFICATIONS | |
Signal injection | Pulse generator | PESD-ECSS-12K | 20 V - 10 kV, positive polarity |
High frequency injection probe | IPDR250 | 10 kHz to 400 MHz, internal diameter 43 mm | |
Test accessories | Coaxial load and attenuators | 1 set | Load 25 W, attenuators 40dB and 20dB |
Measurement equipment | Current sensor | 200 Hz - 500 MHz | |
Oscilloscope | OD2C500M | 500 MHz, 2 channels, 10 GSa/s |
Подробные технические характеристики, информация производителя, брошюры:
-
Каталоги производителя: